Cobra 2000 BLUE Channel display, easy install, no wiring changes, very bright, - $15 - (Ronan, MT)

Channel display with instructions, blue or red, these are not just LEDS you get the whole board ready for soldering. and detailed instructions, same solder positions.. The solder pads seen in the pictures are where the original wires connect. I have included A lenght of wire in case you need to extend the existing wires, and also heat shrink. The 150 ohm you see on the solder side is to dim the display a little, It can be shorted or increased to match the frequency / time display intensity, the higher the resistor the dimmer you can make it. These are the latest generation of displays, very bright and the segments are uniform, no bright spots, like the old. requires stripping and soldering original channel select wires to Tinned pads. Board mounts using same two holes as original. As many people Know these are the best.........Ralph

Posted in Ronan, MT, Electronics
From ebay.com - 1 month ago