Cobra 2000 GTL RED Channel display, no wiring changes, bright, - $15 - (Ronan, MT)

Channel display with instructions, RED these are not just LEDS you get the whole board ready to bolt in and solder. and detailed instructions, same solder positions as the wires comming of the channel switch P.C. board. The solder pads seen in the pictures are where the original wires connect. I have included A lengh of wire in case you need to extend the existing wires, and also heat shrink. The 150 ohm you see on the solder side is to dim the display a little, It can be shorted to increase the intensity, increased to dim it , to match the frequency / time display intensity, the higher the resistor the dimmer you can make it. These are the latest generation of displays, very bright and the segments are uniform, no bright spots, like the old. requires stripping and soldering original channel select wires to Tinned pads. Board mounts using same two holes as original. The Green display is a special case, unlike the red and blue the green requires changing the existing RED channel display lens to a green. Push the channel lens from the inside, It should push out the front with no trouble as the glue used to hold it in place is old, now remove the glued red lens, glue in the green lens, use a glue called "GOOP" ( good glue, bad name ) just little dab of glue on each side of the new lens, press into place and leave for an hour or so. As many people Know these are the best.........Ralph

Posted in Ronan, MT, Electronics
From ebay.com - 1 month ago