50 turn calibration coil Calibrator Accessory / May be compared to a 5500A/Coil - $950 - (Magog, QC)

This a 50 Turns prototype calibration coil. in 100% working condition. ** This coil is entirely homemade and not intended to be as perfect as a manufactured product. ** Please look at all the photos Compare the clamps reading vs AC or DC Calibrator's output and 50:1 ratio + direct reading using the 1 turn loop. I added a direct 1 turn loop. This is very useful feature! No need to unplug the main wire from the calibrator to measure low current (This feature is not found on a Fluke 5500A/Coil) I also installed the connectors at the back of the coil instead of being in the front right side. Note that the main coil cannot accept clamps that has a jaw opening smaller that 1.25 inch. The smaller clamp that can be used is a Fluke 32X series (321, 322, 323, 324) max 500 MCM wire. It was tested using a Fluke 5500A Calibrator up to 11A AC / DC Note: Some calibrators may not have adequate compliance voltage. As a Fluke 5500A calibrator does, depending of the clamp model HIGH AC amp values and test HIGH frequencies. The calibrator may turn into it's compliance voltage protection mode . You will receive the coil and the connection cable as shown. (The 5500A calibrator or current clamps are NOT included) This is a feedback left about 2 years ago when i sold another one Outstanding !! 100% RecomendedBuyer: Member id mpcmx ( Feedback Score Of 333) More than a year ago 50 turn calibration coil - may be compared to a 5500A/Coil (#201791345070) This is a working prototype Sold as is Final Sale No Return Please look at all the photos and do not hesitate to ask questions. Thanks!!!

Posted in Magog, QC, Business for Sale
From ebay.com - 1 month ago